Cozy Search
Chapter Selection
- Chapters (52)
- Completed: (43)
- 00. Preparation (12)
- 01. Description & Introduction (1)
- 02. Bill of Materials (2)
- 03. Education (4)
- 04. Fuselage Bulkheads (5)
- 05. Fuselage Sides (5)
- 06. Fuselage Assembly (2)
- 07. Fuselage Exterior (1)
- 11. Elevators (1)
- 12. Canard Installation (1)
- 13. Nose, Nose Gear & Brakes (7)
- 14. Center Section Spar (4)
- 16. Control System (1)
- 19. Wings, Ailerons & Wing Attach (4)
- In Progress: (11)
- Not Started: (1)
- 22. Electrical (1)
- 25. Finishing (1)
- 26. Upholstery (1)
- Completed: (43)
- Uncategorized (7)
- Chapters (52)
Archives
- March 2018
- May 2017
- January 2017
- February 2016
- January 2016
- April 2015
- August 2014
- January 2014
- October 2013
- July 2013
- February 2013
- December 2012
- October 2012
- June 2012
- May 2012
- April 2012
- February 2012
- January 2012
- December 2011
- November 2011
- October 2011
- September 2011
- August 2011
- July 2011
- June 2011
- May 2011
- April 2011
- March 2011
- February 2011
- January 2011
- December 2010
- November 2010
Meta
-
Join 93 other subscribers
Chad Wilhelm’s Cozy Build
Category Archives: 12. Canard Installation
13 Hrs – Ch12 – Canard Install
Fabricated the small piece that fits between the canard and the torque tube to block the inrush of cold air. Epoxied it in place and put one layer of BID on each side. Trimmed them up after cure, and checked … Continue reading
Posted in 12. Canard Installation, 13. Nose, Nose Gear & Brakes
Tagged aluminum plates, bushings, canard, torque tube
Leave a comment